SHARP SERVICE MODES

Sharp LC-37-RD1E

appuyez sur l’interrupteur d’alimentation, appuyez sur VOL-touches du clavier et entrée pendant quelques secondes.

2 – l’image apparaît sur ​​la lettre K, ce qui indique que ces en service.

3 – appuyez sur les touches Vol-Prog-vous pour accéder au menu

Vous effectuez les modifications, puis de sortir de stanby désactiver la télécommande
FACTORY RESET
VOL- and INPUT/SOURCE then plug in. K appears on screen.
Push CH- and VOL- and quickly release.
Go to 'INIT' then Enter.
Init success. Unplug and wait 10 seconds.

SHARP LED BLINKING RED
Press down on Power' and'Input'(Joystick) then plug in power câble. Keep hold the two buttons until SHARP appears on screen and goes back.
Keep pressing for about one minute and release.
Wait another 3 minutes with TV on. Then disconnect and connect back.

SHARP with JOYSTICK.
-UP, UP, DOWN, DOWN, RIGHT, LEFT, ENTER.

SHARP SERVICE
-unplug mains and wait for full discharge.
-plug back AC while holding down 'Power and ENTER' keys for models 175 and 185M. For the rest, only Power Key.
-Now backlight will turn on but no display.
-Stylé light will start blinking Green.. Red..
Then press password by pressing'Power key 2 times
Single press, hold long pressed.
Once backlight gets on and display shows purple menu test pattern..
From list sélect service mode by single press and hold power key (wait 5 to 10 secs)

SERVICE MODE
-Press Enter and Power and hold, then plug in.
When the front led starts blinking Green, Red, release buttons then quickly press UP, DOWN, UP and keep pressing Enter. The service menu.

---------
ENTER + POWER
UP, DOWN UP. wait 5 secs, then press OK (ENTER).